Advertisement
About HOP and PAIR Functions
Each Audioengine W2 Sender and Receiver set are
Paired out of the box, so if you're only using one set no
further configuration is needed. However, if you wish -to
Pair and Hop to multiple AW2 Receivers refer to the
following instructions.
Pairing
Pairing is a function by which a Sender and Receiver
become acquainted. Once a Sender and Receiver are
Paired, they will remember each other. You can "Pair" a
Sender to more than one Receiver and then "Hop"
between each, or vice-versa.
Pairing a Sender and Receiver:
1) Plug the Sender into your iPod and play music so the
Sender status indicator light is on solid.
2) Press and hold the button on the Sender for about 3
seconds until the status indicator light blinks rapidly.
3) While the Sender's indicator light is still blinking
rapidly, momentarily press the button on the Receiver.
4) The Sender and Receiver's status indicators will both
go solid, indicating that they are Paired.
5) Repeat these steps to Pair additional Senders or
Receivers.
Advertisement
