Install Front Fenders; Install Rops Frame; Activate And Charge Battery - Toro Workman
3300–D Operator's Manual

Install Front Fenders

1. Align the five fender mounting holes with the holes in
each side of body (Fig. 5).
2. Mount a fender to each side of body with (5) #10 x 3/4"
lg. capscrews, (10) flat washers and (5) #10 locknuts.
Position a washer next to capscrew head and locknut.
Figure 5
1. Fender

Install ROPS Frame

1. Insert each side of ROPS into mounting bracket on each
side of vehicle frame, positioning ROPS as shown in
figure 6.
FRONT
Figure 6
1. ROPS
1
1
2
2. Mounting bracket
17
2. Secure each side of ROPS to mounting brackets with
(2) 1/2–13 x 3" lg. capscrews and locknuts.

Activate and Charge Battery

If battery is not filled with electrolyte or activated, it must
be removed from vehicle, filled with electrolyte and
charged. Bulk electrolyte with 1.260 specific gravity can be
purchased from a local battery supply outlet.
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Danger
Battery electrolyte contains sulfuric acid which is a
deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact with
skin, eyes or clothing. Wear safety glasses to
shield your eyes and rubber gloves to protect
your hands.
•
Fill the battery where clean water is always
available for flushing the skin.
1. Loosen knobs securing battery cover to battery base and
slide cover off.
2
Figure 7
1. Battery cover
2. Knob
1
2
3
3. Battery base