Pre-Treating - Bissell little green 1400 series User Manual

O
peration
Getting ready (continued)
2.
Release vacuum flex hose by twisting the bracket
latch clockwise. Unwrap vacuum flex hose com-
pletely from around the unit.
3.
Attach your selected cleaning tool to the spray trigger
unit by pressing tool onto spray trigger firmly until
the button lock snaps into hole. Make certain the tool
is securely attached.
4.
Twist the Quick Release cord wrap clockwise to
unwrap the power cord completely from onboard
cord storage and plug into 120 Volt, 60 Hz grounded
outlet as described in Important safety Instructions,
page 3.
5.
Press power switch to ON position. If your model
has a heater switch then press the red heater
switch to "ON". Within 30 seconds, the heat
indicator light will illuminate, indicating the
heater has reached the proper temperature.
Begin by pressing the spray trigger for 5-10
seconds to allow the non-heated water to travel
through the heater.
6.
Press and hold spray trigger—spray will start in a
few seconds. Raise the tool slightly to check for spray.

Pre-treating

Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly-soiled areas.
Here's how to do it:
1.
Hold the cleaning tool just above the surface of
the carpet or upholstery to be cleaned. Press the
trigger to release a spray of cleaning solution
directly onto the soiled area.
2.
Wait 3-5 minutes before cleaning.
w w w . b i s s e l l . c a
2.
3.
5.
Power Switch
Heater Switch*
*Select Models only
WARNING:
Be sure to unplug the
cord before attaching
the TurboBrush (select
models only).
1 - 8 0 0 - 2 6 3 - 2 5 3 5
4.
6.
Spray Trigger
7