Pre-Treating - Bissell LITTLE GREEN 1425 User Manual

O
peration
Getting ready (continued)
2.
Unwrap vacuum flex hose completely from
onboard hose storage.
3.
Attach your selected cleaning tool to the spray
trigger unit by pressing tool onto spray trigger
firmly until the button lock snaps into hole. Make
certain the tool is securely attached.
4.
Twist the quick release cord wrap clockwise to unwrap
the power cord completely from onboard cord
storage and plug into 120 Volt, 60 Hz grounded outlet as
described in Important safety Instructions, page 3.
5.
Press power switch to ON position. Press the red
heater switch to "ON". Within 30 seconds, the heat
indicator light will illuminate, indicating the heater
has reached the proper temperature.
6.
Begin by pressing the spray trigger for 5-10
seconds to allow the non-heated water to travel
through the heater.
7.
Press and hold spray trigger—spray will start in a
few seconds. Raise the tool slightly to check for spray.

Pre-treating

Cleaning effectiveness will be enhanced if you
pre-treat heavily stained or highly-soiled areas.
Here's how to do it:
1.
Hold the cleaning tool just above the surface of
the carpet or upholstery to be cleaned. Press the
trigger to release a spray of cleaning solution
directly onto the soiled area.
2.
Wait 3-5 minutes before cleaning.
w w w . b i s s e l l . c o m
2.
3.
5.
Power Switch
Heater Switch
WARNING:
Be sure to unplug the
cord before attaching
the TurboBrush (select
models only).
8 0 0 . 2 3 7 . 7 6 9 1
4.
6.
Spray Trigger
7