Front Middle Back ANT3036W / ANT3036X Outdoor Antenna User’s Guide BEFORE YOU START!!! included in this package. Step 1: Unpack Remove all three sections of the antenna and the hardware bag from package. Make sure the following parts are in the package:...
Page 2
Step 3: Unfold the back section one set of elements). Back section section. VHF element Step 4: Connect the back section to the middle section Middle section blue on the boom. Find the same stamp on the boom of the back section. Line up both booms Remove the screw and nut from end of the middle section closest to the back section.
Page 3
Step 5: Unfold the front section Find the front section of the antenna Front (illustrated on the left). section (illustrated below). Reflector booms closest to the main boom, unfold the element until it locks into place. place.
Page 4
Step 6: Connect the front section to the middle section Front section red on the boom. Find the same stamp on the boom of the middle section. Line up both Remove the screw and nut from end of the middle section closest to the front section. Insert the crimped end of the front section into the middle section as illustrated on the left.
Step 8: Attach the mast clamp insert Find the U-bolt and mast clamp insert (see the illustration to the left). Put the U-bolt into the mast clamp insert with the teeth of the mast clamp insert facing the closed end of the U-bolt.
Step 11: Attach the antenna to the mast IMPORTANT: Before you attach the antenna to your mast, visit www.antennaweb.org to see the locations of your local broadcast towers. This information is crucial in pointing your antenna correctly. Loosen the nuts on the mounting clamp U-bolt as needed.