Service Adjustments - Sanyo CE32FWH2F-C Service Manual

SERVICE ADJUSTMENTS

Note: Some items of the service adjustments for this chassis are controlled by the CPU, IC801, and the
adjustments are carried out by using the RC handset.
INITIALISATION OF MEMORY IC
To initialise the memory IC (IC803), press and hold the NORMAL
P button on the front panel of the TV set and then turn the Mains switch Off and On. The initialisation is now
completed.
When initialised the memory IC and all of the setting data (option data and service adjustment data) stored in the IC
are reset to the default value. It is necessary to set the option settings and readjust the service adjustments listed on
page 6 and to re-tune all the channels.
The available adjustment items are as follows;
TDA9885 : This can be adjusted for AGC.
Image : This can be adjusted for picture images/shapes.
Video : This can be adjusted for the service adjustment.
DO NOT ADJUST OTHER SETTINGS
[After replacing the Memory IC (IC803)]
The memory IC, IC803, stores the service adjustments data for each circuit, therefore, when the memory IC is
replaced, it should be programmed by using "OPTION SETTING" on previous page and the following adjustments.
TO ENTER SERVICE ADJUSTMENTS
While pressing the green button on the remote control press the P
appears.
SW Vers 1.2.0
Use the P or P to highlight the service menu you require and press the F/OK button to enter.
TO EXIT SERVICE ADJUSTMENTS
Press the Menu button to navigate backwards through the service menus until menus disappear.
IMPORTANT NOTICE
Do not attempt to adjust service adjustments not listed on the above otherwise it may cause
loss of performance and product safety.
C6BLL
Service
Video
Sound
STV2310
TDA9885
STV8206
TDA9330
Others
Image
WSS
button on the remote control, then press the
on the cabinet front. The service menu
-6-