Unpacking And Assembly - Impax IM-MIG150 Instruction Manual

UNPACKING AND ASSEMBLY

Unpacking
Caution! This packaging contains sharp objects.
Take care when unpacking. Remove the
machine, together with the accessories
supplied, from the packaging. Check carefully to
ensure that the machine is in good condition
and account for all the accessories listed in this
manual. Also make sure that all the accessories
are complete. If any parts are found to be
missing, the machine and its accessories should
be returned together in their original packaging
to the retailer.
Do not throw the packaging away, keep it safe
throughout the guarantee period, then recycle if
possible, otherwise dispose of it by the proper
means. Do not let children play with empty
plastic bags due to the risk of suffocation.
Assembly
Note: Before carrying out any assembly or
disassembly of the unit please ensure that the
unit is not connected to the electrical supply.
Assembling the Face Mask
To assemble the mask bend in the top and side
flaps (Fig.1) and clip into place then attach the
handle and mask glass shield as shown in Fig.2.
Fig 1
Fig 2
Insert the clear glass panel first, followed by the
dark glass panel into the recess in the shield,
i.e. the clear glass MUST be on the outside of
the shield. Securing them with the plastic
screws provided.
The dark panel is a certified, specific optical
class, and should not be exchanged for any
other type.
The clear glass panel should be replaced when
it becomes badly pitted.
Warning! NEVER look at an electric arc without
eye protection as this can injure the eyes
permanently. ALWAYS use a protection mask or
welding helmet.
Installing the Welding Wire
Unscrew the shroud from the end of the torch
then unscrew the contact tip (Fig.3).
Fig 3
Open up the side cover of the welder. If the wire
spool is mounted on the spool holder, it needs
to be removed in order to remove the plastic
wrapper. To do this, proceed as follows:
Unscrew and remove the plastic knob (A),
followed by the spring and collar (B) from the
hub, Fig.4.
Fig 4
A
13
Contact tip
Shroud
B