Toyota Avalon Owner's Manual page 24

The ceiling mounted garage door opener
motor should now recognize
R
HomeLink unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
R
maining HomeLink button to program
another rolling code system.
Programming an entrance gate/Program-
ming all devices in the Canadian market
R
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand- held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface of
R
HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and hold the selected
R
HomeLink button.
4. Continuously press and release (cycle)
the hand- held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light on
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
250
'06 AVALON_U (L/O 0508)
6. Test the operation of the HomeLink
the pressing the newly programmed button.
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
R
maining HomeLink button to program
another device.
Programming other devices
To program other devices such as home
but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
the R
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
R
button, follow the procedure "Programming
R
the HomeLink ".
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the
R
appropriate HomeLink button to activate
the programmed device. The HomeLink
indicator light should come
R
HomeLink continues to send the signal
for up to 20 seconds as long as the
the
button is pressed.
I n f o r ma t i o n P r o v i d e d b y :
R
by
(c) Erasing the entire
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
R the programs stored in the HomeLink
memory.
on. The
For additional programming assistance
with your HomeLink
Transceiver call the:
D
Toyota Customer Experience Center at
1- 800- 331- 4331 (U.S.A.)
D
Toyota Canada Customer
Centre at 1- 888- 869- 6828 (Canada)
R
HomeLink
R
R
Universal
Interaction