Toyota Avalon Owner's Manual page 23

2006
Hide thumbs Also See for Avalon:
Table of Contents

Advertisement

3. Simultaneously
press
and
hold
hand- held
garage
transmitter
button
R
along with the selected HomeLink
ton.
Do not release the buttons until step 4
has been completed.
4. When
the
indicator
light
on
R
HomeLink
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
'06 AVALON_U (L/O 0508)
the
5. Test the operation of the HomeLink
pressing the newly programmed button.
but-
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
the
"Rolling Code" type. Press and hold the
R
programmed HomeLink
button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
I n f o r ma t i o n P r o v i d e d b y :
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink
button to program
another device.
Programming a rolling code system
If
your
device
is
"Rolling
equipped,
it
is necessary
steps 1 through 4 under the heading
"Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
R
door
opener.
Refer
to
by
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
3. Press and release the vehicle's pro-
R
grammed HomeLink
button twice. The
R
)
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
Code"
to
follow
R
" before
the owner's
249

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents