Zero Configuration Setup - D-Link DCS-2330L Quick Install Manual

Zero Configuration Setup

The Zero Configuration Setup will only work with a registered
Cloud Router and an active mydlink account. Your Cloud Router will
automatically assign your network settings (both wired and wireless)
to your camera, and add it to your mydlink account.
If you do not have a D-Link Cloud Router, skip to the Easy Setup section.
Remove the rubber plug on the back of
1
the camera. Then connect the Ethernet
cable to the Ethernet port and press the
rubber gasket that is attached to the
cable firmly into the hole.
Connect the other end of the Ethernet
2
cable to your D-Link Cloud Router and
connect the camera's power adapter to
a power outlet.
If using a wireless connection: Press
and hold the WPS button on the back
of the camera for five seconds. The
blue WPS status LED will start to blink.
Then, press the WPS button on your
Cloud Router within two minutes.
From any computer, open a web
3
browser, go to http://www.mydlink.
com and log into your account. Once
mydlink detects your camera, a notice
will appear that there is a new device
detected. Click on your camera name
from the New Devices list and then
click Yes to add your camera.
For wireless connection, remove the
4
Ethernet cable and reinstall the rubber
cover for proper weatherproofing.
Your setup is complete!
DCS-2330L
5