Table of Contents
Advertisement
Orange Pi User Manual
Note : The micro-usb power connector can only make
system startup, and the SATA is not available. If you want to start all
available systems(such as
you need to use DC power connector.
6. If you have a free 2.5 inch hard drive, you can put it into use on
Orange Pi. Connect the SATA cable to the SATA port just on the left
of HDMI. Remember to put the power cable with 2 male 2.54mm
headers into the SATA power. Then you can plug your hard drive into
the other side of the SATA cable. Be careful with the connection of
different color cables. (This step can be skipped)
If all goes well, the Orange Pi will boot in a few minutes. The screen
will display the OS GUI(Graphical User Interface). The first boot of a
new OS can sometimes take a long time. Be patient!
Subsequent boots are usually much quicker.
Step4: Shut down your Orange Pi
You can use the GUI to shut down the Orange Pi safely.
Also you can run the command in the terminal:
sudo halt
or
sudo shutdown –h.
This will shut down the PI safely, (just use the power key to turn off
mightdamage the TF-cards file system). After that you can press the
power key for 5 seconds to turn it off.
If all is well ,so you can use orange pi now.
GPIO specification
Orange Pi 40-pin GPIO
Orange Pi has a 40-pin GPIO header that matches that of the Model A and Model B
www.orangepi.org
Shenzhen Xunlong Software CO., Limited
Android, Lubuntu
Android
), or want to test SATA,
www.xunlong.tv
Advertisement
Table of Contents
