Table of Contents
Advertisement
Orange Pi User Manual
1. Insert the written-image TF card into the TF card slot on the left
side edge of the upside of the board.
2. On the bottom edge in the middle of the board is the HDMI Type A
(Full sized) port, just on the right of the SATA port. Just connect
any HDMI Type A cable from the board to your TV or HDMI
Monitor.
If you don't have an TV/Monitor with a HDMI or DVI-D port you
can use the AV jack located on the right edge above USB HOSTs.
3. Plug a USB keyboard and mouse into the USB slots located on the
right edge.
4. Just under the USB ports on the right edge is the ethernet
connector for anyone who wants to plug the Orange Pi into a wired
network. You can also use wifi to connect network.
5. Finally, at the middle of the left edge is the DC power
connector. Plug in a regulated power supply that is rated at 5V ±
5% and at least 1500mA (or 2.0A). Any number bigger than 1500
mA will also work. On the left edge, under the power switch is the
micro-usb power connector. Avoid using the smaller chargers
used for small GSM phones, as these are often unregulated, even if
they claim "5V 2A", they may do "5V" and may do "2A", but not at
the same time! Make sure you have the correct USB plug. In the
photo below, the mini-USB (on the left) is the wrong one. It's
thicker and looks like a trapezoid with its sides pinched in. The
micro-USB (on the right) is the correct one. It is thinner and also
looks like a trapezoid except it's sides are rounded outward.
www.orangepi.org
Shenzhen Xunlong Software CO., Limited
www.xunlong.tv
Advertisement
Table of Contents
