Mounting The Unit: Bracket Or In-Dash; Bracket Installation - Lowrance GlobalMap 7000C Operation Instructions Manual

Communication Port Wiring Diagrams
Com-1
To unit
Com-1 wiring to receive DGPS position information
Com-1
To unit
Com-1 wiring to receive NMEA position information
Com-1
To unit
Com-1 wiring to transmit NMEA position information
Com-2
To unit
Com-2 wiring to transmit NMEA position information

Mounting the Unit: Bracket or In-Dash

You can install the GlobalMap 7000C on the top of a dash with the
supplied gimbal bracket. It can also be installed in the dash. For an in-
dash mount, consult the factory customer service department. Service
contact information is inside the back cover of this manual.

Bracket Installation

Mount the GlobalMap 7000C in any convenient location, provided there
is clearance behind the unit when it's tilted for the best viewing angle.
You should also make sure there is enough room behind the GlobalMap
7000C to attach the power and GPS antenna/receiver module cables. (A
drawing on the next page shows the dimensions of a gimbal-mounted
GlobalMap 7000C.)
Yellow (Transmit)
Orange (Receive)
Shield (Ground)
from a DGPS receiver.
Orange (Receive)
Shield (Ground)
from some other GPS receiver.
Yellow (Transmit)
Shield (Ground)
to another NMEA-compatible device.
Blue (Transmit)
Shield (Ground)
to another NMEA-compatible device.
Receive
Transmit
Ground
NMEA Transmit
Ground
NMEA Receive
Ground
NMEA Receive
Ground
14
To DGPS
Receiver
To Other
GPS Receiver
To Other
Device
To Other
Device