Shindaiwa C242 Owner's/Operator's Manual page 5

Safety Instructions
Equipment
WARNING!
Use only ECHO Inc. attachments. Serious injury may result from the use of a non-approved
attachment combination. ECHO Inc. will not be responsible for the failure of cutting devices, attachments
or accessories which have not been tested and approved by ECHO Inc. Read and comply with all safety
instructions listed in this manual.
■
Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
■
Inspect the debris shield for damage and ensure that the cut-off knife is securely in place. Replace if
either is damaged or missing.
■
Check that the cutting attachment is firmly attached and in safe operating condition.
■
Check that the handle(s) and harness (if included) are adjusted for safe, comfortable operation. See
Assembly section for proper adjustment.
■
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects
away from all openings.
■
ALWAYS stop engine, disconnect spark plug, and make sure all moving parts have come to a com-
plete stop before removing obstructions, clearing debris, or servicing unit.
■
DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.
■
NEVER reach into any opening while the engine is running. Moving parts may not be visible through
openings.
■
Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or
leaks are found, do not use unit, otherwise serious personal injury or property damage may occur.
Have unit repaired by an authorized servicing dealer before using.
DANGER!
All over head electrical conductors and communications wires can have electricity flow with high
voltages. This unit is not insulated against electrical current. Never touch wires directly or indirectly,
otherwise serious injury or death may result.
Read the Manuals
Provide all users of this equipment with the Operator's Manual for
instructions on Safe Operation.
Clear the Work Area
Spectators and fellow workers must be warned, and children and
animals prevented from coming nearer than 15 m (50 ft.) while the unit
is in use.
Keep a Firm Grip
Hold both handles with thumbs and fingers encircling the grips.
Keep a Solid Stance
Maintain footing and balance at all times. Do not stand on slippery,
uneven or unstable surfaces. Do not work in odd positions or on
ladders. Do not over reach.
C242 Brushcutter
5