Table of Contents
Advertisement
2.5
Power ON
Check connections and plug in power supply
Double check whether all cables/connectors are properly connected. You can check the color of
keyboard and mouse connector to make sure the keyboard and mouse cables go to the correct port.
Plug the power supply to the KVM switch and plug the AC power plug into the electrical receptacle.
Now you will see the LED of Port 1 lights up, and hear a beep sound.
Recommend Power ON sequence as follows: Monitor, KVM Switch, finally Computer.
2.6
CAT. 5 KVM Receiver (R-Box)
The CAT.5 KVM receiver (R-Box) uses CAT.5 cable to extend your keyboard, mouse and monitor
1000 feet (300 meters) away from the KVM switch. It also has built-in 2-to-1 OSD KVM switch for
selecting remote or local Computer.
2.7
CAT. 5 Receiver Installation
2.
Make sure the CAT.5 cable is straight through type.
3.
Plug one end of CAT.5 cable into RJ-45 connector of the KVM switch CAT.5 console port, and
plug the other end of CAT.5 cable into RJ-45 port of the R-Box.
4.
Connect keyboard, mouse and monitor to the R-Box console ports (USB Keyboard / Mouse
port, and VGA port)
5.
Connect Local Computer to R-box with the accompanied 3-in-1 HDDB15 cable.
6.
Power on the R-Box by plugging in the power adaptor
7.
Push the SELECT button to select remote or local Computer.
Figure 14. Connect to CAT. 5 Receiver (R-Box)
12 / 19
1+1 Console Combo KVM Switch
Advertisement
Table of Contents
