Planning Installation - A QR034 Owner's Manual

Pre-Installation (continued)

PLANNING INSTALLATION

Number of people required: 2 or more
Carefully check the range hood for damage and for missing parts prior
to installation . If there is any damage or if you are missing parts, do
not proceed with the installation . Report damage and missing parts
immediately. Do not dispose of packaging before you are satisfied with
your new range hood .
1 . Before installation, measure all distances to ensure the proper position
of the range hood (A) .
- The distance (1) from the cooking surface to the range hood
must be at least 18 in . (458 mm) . For the best performance, do
not install the range hood more than 32 in . (813 mm) above the
cooking surface .
- Dimension (3) should be at least 30" (762 mm). The range hood
should be approximately the same size as the cook top.
2 . If the bottom of the cabinet (6) above the location where the range hood
is to be installed is recessed, attach appropriately sized wood filler strips
(7) on each side using wood screws .
3 . Screws are provided to secure the range hood to most types of cabinets,
but consult a qualified installer to verify that the supplied screws are
suitable for your cabinets .
4 . Put a thick, protective covering over your counter, cooktop, or range
to protect it from damage and dirt during installation . Remove any
hazardous objects around the area .
VENTING OPTION:
This unit is a top venting range hood .
You must use a top venting system that vents to the outdoors as shown in Fig . 4 and Fig . 5 .
Ensure that you have enough vertical space in the cabinet as to allow for the housing of the motor and any ductwork necessary for your
installation .
Horizontal Wall Venting
15
13
Fig.4
WARNING: Always wear safety goggles and gloves
during installation .
4
6 7
Vertical Roof Venting
16
14
Fig.5
8
7
7
A
3
3
Fig . 3
1