Travis Industries 1750 Owner's Manual page 35

Lopi owner's manual wood stove 1750

Hide thumbs Also See for 1750:

Bend the legs on the snap

disk assembly until it is

approximately 1-5/8" thick.

This will help it fit tightly into

the rear convection channel.

1-5/8"

Attach the blower to the stove with the

three screws included with the blower.

3/8" Wrench

Plug the blower in. Do not route the power cord under or over the stove or in a

location where it may become damaged.

Remove these two knock-outs on

the bottom of the stove (use a

screwdriver to pry them out).

Attach the wires from

the thermodisk to the

wires from the blower.

Position the blower near the rear of the stove. Tuck all excess wire into the

blower box, making sure it does not contact any moving parts. Make sure when

installing the blower, these wires do not become loose.

Twist the wires together on the snap disk

assembly. Wedge the snap disk into the

rear convection channel. Make sure the

snap disk contacts the firebox (not the back

of the convection jacket).