Kenmore 796.29002 Service Manual page 22

2) Disassembly of the Noise Filter,
Noise Filter and Power Cord(Figure A)
① Remove the two screws attaching the noise filter.
② Disconnect 2 connector in Noise Filter and
Disassemble Noise Filter and Power Cord.
Inlet Valve (Figure B)
① Disconnect the leads from the inlet valve and remove
three screws.
② Remove the hoses and output pipes from the input
valve.
③ Remove the inlet valve.
Pressure Switch (Figure C)
① Disconnect the leads from pressure switch and
disassemble pressure switch
② Disconnect pressure tube from the pressure switch .
DT Housing (Figure D)
① Remove the hoses and output pipes from the input
valve.
② Disassemble the connector pipe and the DT housing.
22
Power Cord, Inlet Valve, Pressure
Switch, and DT Housing.