Switching On And Off - Stanley STPP7502 Original Instructions Manual

Emptying the shavings collection bag
The shavings collection bag should be emptied regularly
while using it to prevent blocking.
• Unzip the bag and empty it before continuing.
Use
Warning! Let the tool work at its own pace. Do not overload.
• Adjust the depth of cut.
• If necessary, fit and adjust the parallel fence.

Switching on and off

Switching on
• Keep the lock-off button (2) depressed and press the
on/off switch (1).
• Release the lock-off button.
Switching off
• Release the on/off switch.
Planing
• Hold the tool with the nose piece of the shoe resting on
top of the workpiece surface.
• Switch the tool on.
• Move the tool steadily forward to perform the cutting
stroke.
• Switch the tool off after the stroke has been completed.
Rebating (fig. F)
• Fit and adjust the parallel fence.
• Proceed as for planing.
Chamfering edges (fig. G)
The V-groove in the nose piece of the shoe enables you to
chamfer edges at 45°, 30° and 15° angles.
(Original instructions)
• Hold the tool at an angle with the desired groove (20)
around the edge of the workpiece and perform the
cutting stroke.
Parking rest (fig. H)
Your planer is equipped with a parking rest (21) that
automatically lowers into place when the tool is lifted from
the work surface. When planing, the parking foot raises as
the tool is pushed forward. When the parking foot is lowered,
the planer can set on the work surface without the blade
touching.
Hints for optimum use
• Move the tool along the grain of the wood.
• If the grain is cross or curly, or if the workpiece material
is a hard type of wood, adjust the depth of cut to take
only a very thin shaving at each pass and take several
passes to achieve the desired result.
• To keep the tool in a straight line, press down the front of
the tool at the start, and press down the back of the tool
at the end of the cutting stroke.
Accessories
The performance of your tool depends on the accessory
used. STANLEY and Piranha accessories are engineered to
high quality standards and designed to enhance the
performance of your tool. By using these accessories you
will get the very best from your tool.
The following types of cutting blades can be obtained from
your local retailer:
- Tungsten carbide tipped reversible cutting
blades (part no. X35007, supplied per pair)
- High-speed steel reversible cutting blades
(part no. X24192-XJ11, supplied per pair)
ENGLISH
9