Floormat - Mercedes-Benz CLS Operator's Manual

Features
278
X
Press and hold button =(
approximately three seconds.
The currently selected zone appears in
compass display ;(
X
To select the zone: press
button =( Y
desired zone is selected.
The zone has been selected when compass
display ;( Y
This takes a few seconds.
Calibrating the compass
X
Make sure that there is sufficient space for
you to drive in a circle without impeding the
remaining traffic.
In order to calibrate the compass correctly,
observe the following points:
calibrate the compass in the open and not
R
in the vicinity of steel constructions or high-
voltage transmission lines.
switch off electrical consumers, for
R
example, the climate control, windshield
wipers or rear window defroster.
close all doors and the trunk lid.
R
X
Switch the ignition on.
X
Press and hold button =(
approximately six seconds until the
C
symbol appears in compass display ;
( Y page 277).
X
Drive a full circle at approximately 3 mph
(5 km/h) to 6 mph (10 km/h).
Once the calibration has been successfully
completed, the current direction appears in
compass display ;(
Floormat on the driver's side
G
WARNING
Whenever you are using a floormat, make sure
there is enough clearance and that the
floormat is securely fastened.
The floormat should always be securely
fastened using the fastening equipment.
Y page 277) for
Y page 277).
page 277) repeatedly until the
page 277) shows the heading.
Y page 277) for
Y page 277).
Before driving off, check that the floormat is
securely in place and adjust it if necessary. A
loose floormat could slip and hinder proper
functioning of the pedals.
Do not place several floormats on top of each
other as this may impair pedal movement.
X
Slide the seat backwards.
X
To install: place the floormat in the
footwell.
X
Press studs : onto retainers ;.
X
To remove: pull the floormat off
retainers ;.
X
Remove the floormat.
I n f o r ma t i o n P r o v i d e d b y :