System Configuration; How To Insert Batteries; How To Use The Remote Control - Lennox OLR-1X
 User Manual

TABLE OF CONTENTS
CONTENTS
• SYSTEM CONFIGURATION
• HOW TO INSERT BATTERIES
• HOW TO USE THE REMOTE CONTROL
• INFRARED REMOTE CONTROL
• DISPLAY INDICATORS
• OPERATION
• PROGRAMMING ADJUSTMENT
• RECEIVER INDICATORS
• ALARM
• UNIT PROTECTION DEVICES

SYSTEM CONFIGURATION

This control is valid for operating as a cooling only or heat pump application. The control for the indoor unit
is the same for operating with outdoor units cooling only or heat pump. The indoor unit should be configured
prior to making the electrical connections, by setting the switch for heat pump or for cooling only unit .
For further details, follow the OPERATION AND SERVICE MANUAL in the indoor unit.

HOW TO INSERT BATTERIES

USE 2 AAA LR3 TYPE 1,5V ALKALINE BATTERIES.
Push the cover of the wire less remote control and slide it to
remove. Insert batteries in the compartment, paying special
attention to the correct polarity indicated in the battery
compartment.
Replace the cover.
CAUTIONS
Life of batteries is about 12 months under normal conditions.
If the remote control does not work, or it only works near the
unit, the batteries must be replaced.
Never use used batteries. Always use the same type of
battery.
The batteries must be removed from the remote control if not
used for a long period.

HOW TO USE THE REMOTE CONTROL

Direct the remote control transmitter towards the unit receiver window and enter choice on the controller. A "beep" will indicate
that the signal has been received.
The unit will not respond to the control signal if there is an object between the remote control and the unit.
The maximum operating range for the remote control is approximately 7 meters.
AUTO
H M L
°F
°C
FAN
1
PAGE
1
1
1
2
2
3
4
5
5
6
MODE
Remove batteries
if not used for
long period