Samsung 450S Installation Manual page 7

✎ Whenever you connect an external device to your TV, make sure that power on the unit is turned off.
✎ When connecting an external device, match the colour of the connection terminal to the cable.
USB (5V 0.5A) / CLONING
1
– Connector for software upgrades and Media Play, etc.
– Service connection.
– USB CLONING support 2.0 Standard only.
COMMON INTERFACE
2
ANT IN
3
– To view television channels correctly, the TV must receive a signal from one of the following sources:
– An outdoor antenna / A cable television system
HDMI IN: Connects to the HDMI jack of a device with an HDMI output.
4
✎ No sound connection is needed for an HDMI-HDMI connection. HDMI connections carry both audio and video.
✎ Use the HDMI IN (DVI) jack for a DVI connection to an external device. Use a DVI to HDMI cable or DVI-HDMI
adapter (DVI to HDMI) for the video connection and the PC/DVI AUDIO IN jacks for audio.
5 RJP: This port is an RJP (Remote Jack Pack) communication port that enables connecting different devices to
additional modules to improve device use and convenience.
HEADPHONE JACK: Headphones may be connected to the headphone jack on your TV. While the headphones are
6
connected, the sound from the built-in speakers is disabled.
DATA
7
– Used to support data communication between the TV and the SBB.
– Connects using RJ-12 TV type plugs.
8 HP-ID: Connect the cable to HP-ID and Headphone Jack simultaneously and connect it to separated Headphone
Box. See page 15. When connecting Headphone to Headphone Box, it works same as Headphone function.
EXT (RGB)
9
– In Ext. mode, DTV Out supports MPEG SD Video and Audio only.
AV IN
0
– Connects the Component video / audio.
– Connect the component video cables (optional) to the component jacks ("PR", "PB", "Y") at the back of your TV
and the other ends to the corresponding component video out jacks on the DVD.
– If you wish to connect both the Set-Top Box and the DVD player, you should connect the Set-Top Box to the DVD
Player and connect the DVD Player to the component jacks ("PR", "PB", "Y") on your TV.
– The PR, PB and Y jacks on your component devices (DVD) are sometimes labeled Y, B-Y and R-Y or Y, Cb and
Cr.
– Connect the RCA audio cables (optional) to [R - AUDIO - L] at the back of the TV set and the other ends to the
corresponding audio out jacks on the DVD Player.
7
English