Sticky Scene Select; Scene Revert - Fractal Audio FX8 Owner's Manual

7 : SceneS

STICKY SCENE SELECT

The FX8 normally goes back to Stompbox Mode once you select a scene with the footswitches.
Sticky Scene Select Mode keeps the FX8 in Scene Select mode so you can change from scene to scene
using single footswitch taps.
In Sticky Scene Select Mode, the SCENE footswitch LED stays lit and the FX8 remains in Scene Select Mode
until you manually exit by pressing the SCENE footswitch again.
TO ENABLE/DISABLE STICKY SCENE SELECT MODE...
1. Press the SETUP button.
2. Press the #3 footswitch to open the GLOBAL menu.
3. Use the NAV knob to select "STICKY SCENE SELECT"
4. Use the VALUE knob to select "OFF" or "ON".
5. Press the EXIT button twice to return to Stompbox Mode. (You do not need to STORE changes in
SETUP.)
BONUS: You can still change X/Y for any effect using Press & Hold while in Scene Select Mode!

SCENE REVERT

Scene changes are normally retained until you change the preset. With SCENE REVERT turned on, scene
changes are discarded as soon as you change to a new scene.
Here is a comparison of how scene changes work in both modes:
SCENE REVERT OFF (default)
1. You load SCENE 1. DRIVE 1 is OFF.
2. You turn DRIVE 1 ON.
3. You change to SCENE 2.
4. You change BACK to SCENE 1.
5. Drive will be ON as you last left it.
TO ENABLE/DISABLE SCENE REVERT:
1. Press the SETUP button.
2. Press footswitch 2 to load the I/O menu.
3. Turn to the MIDI page.
4. Use the NAV knob to select "SCENE REVERT".
5. Use the VALUE knob to select "OFF" or "ON".
6. Press the EXIT button twice to return to Stompbox Mode. (You do not need to STORE changes in SETUP.)
SCENE REVERT ON
1. You load SCENE 1. DRIVE 1 is OFF.
2. You turn DRIVE 1 ON.
3. You change to SCENE 2.
4. You change BACK to SCENE 1.
5. Drive will be OFF as it was last saved.
38