Dc Voltage Measurements; Operating Instructions - Circuit-test DMR-6700 User Manual

Operating Instructions

WARNING: Risk of electrocution. High-voltage circuits, both AC and DC,
are very dangerous and should be measured with great care.
1. ALWAYS turn the function switch to OFF position when the meter is not
in use.
2. If "OL" appears in the display during a measurement, the value exceeds
the range you have selected. Change to a higher range.

DC Voltage Measurements

CAUTION: Do not measure DC voltages if a motor on the circuit is being
switched ON or OFF. Large voltage surges may occur that can damage
the meter.
1. Set the function switch to the
2. Press MODE (if required) so DC appears on the
display.
3. Insert the black test lead banana plug into the nega-
tive COM jack. Insert the red test lead banana plug
into the positive V jack.
4. Touch the black test probe tip to the negative side of
the circuit. Touch the red test probe tip to the positive
side of the circuit.
5. Read the voltage in the display.
position.
- 10 -