Table Of Contents - Tanaka TCG 24EBS (SL) Handling Instructions Manual

MEANINGS OF SYMBOLS
NOTE: Some units do not carry them.
It is important that you read, fully
understand and observe the following
safety precautions and warnings. Careless
or improper use of the unit may cause
serious or fatal injury.
Read, understand and follow all warnings
and instructions in this manual and on
the unit.
Always wear eye, head and ear protectors
when using this unit.
Do not use metal/rigid blades when this
sign is shown on the unit.
Keep all children, bystanders and helpers
15 m away from the unit. If anyone
approaches you, stop the engine and
cutting attachment immediately.
Be careful of thrown objects.
Shows maximum shaft speed. Do not use
the cutting attachment whose max rpm is
min
-1
below the shaft rpm.
Gloves should be worn when necessary,
e.g., when assembling cutting equipment.
Use anti-slip and sturdy footwear.
Before using your machine
• Read the manual carefully.
• Check that the cutting equipment is correctly assembled and adjusted.
• Start the unit and check the carburetor adjustment. See "MAINTENANCE".
Contents
WHAT IS WHAT .................................................................................3
WARNINGS AND SAFETY INSTRUCTIONS ...................................4
SPECIFICATIONS .............................................................................5
ASSEMBLY PROCEDURES ..............................................................6
OPERATING PROCEDURES ............................................................9
MAINTENANCE ............................................................................... 11
TROUBLESHOOTING .....................................................................15
2
Symbols
WARNING
The following show symbols used for the machine. Be sure that you understand their meaning before use.
Choke - Run position (Open)
Choke - Start position (Closed)
Ignition stop
Fuel and oil mixture
4
Guaranteed Sound power level
Hot Surface - Contact with hot surface
can cause serious burns.
Blade thrust may occur when the
spinning blade contacts a solid object
in the critical area. A dangerous
reaction may occur causing the entire
unit and operator to be thrust violently.
This reaction is called blade thrust. As
a result, the operator may lose control
of the unit which may cause serious or
fatal injury. Blade thrust is more likely
to occur in areas where it is diffi cult to
see the material to be cut.
Indicate handle location. Do not attach
handle above this point.