Connection Method 3: Connecting To A Wi-Fi Network Using A Pc Connected Wirelessly (Windows 8 Ui) - Sony SRS-X7 Help Manual

Help Guide
How to Use
Personal Audio System
SRS-X7

Connection method 3: Connecting to a Wi-Fi network using a PC connected wirelessly (Windows 8 UI)

Note that the speaker should be initialized to the factory default for this connection. All BLUETOOTH device registration
(pairing) information are deleted.
This section describes how to connect a Windows 8 UI PC and the speaker wirelessly, then connect to a wireless router,
using the PC.
Check the following before starting the operation.
Disconnect the LAN cable from the speaker.
Place the speaker closer to the wireless router.
Set the Wi-Fi antenna on the rear to the upright position.
Set the NETWORK OFF/ON switch on the rear of the speaker to ON.
1. Have the Wi-Fi network name (SSID) and password of the wireless router available for reference.
For details, refer to the operating instructions of your wireless router.
2. With the speaker turned on, press and hold the VOL (volume) – button and the
same time for more than 5 seconds.
The power of the speaker turns off automatically. The settings of the speaker return to their factory defaults, and
network settings and all BLUETOOTH device registration (pairing) information are deleted.
3. Turn on the speaker.
The (on/standby) indicator lights up in green, then the LINK indicator begins to flash.
When you configure the settings of the speaker for the first time after purchase, or after you initialize the speaker,
wait until the LINK indicator turns off (about a minute).
4. Connect the speaker to the PC.
i. Move the mouse pointer to the top-right (or bottom-right) corner of the Start screen to display the charms, then
select [Settings]. In the case of a touch panel, display the charms by swiping from the right side of the Start
screen, then select [Settings].
(on/standby) button at the
151