To Reduce The Risk Of Kickback; Intended Use - Black & Decker CS1015 Instruction Manual

TO REDUCE THE RISK OF KICKBACK

times.
causing a pinched blade.
will lead to blade pinching.
and will pinch blade.
1
2
gure 3) and solidly supported and
portion of the saw shoe is on the portion
of the material that doesn't fall after the cut
is made. Never hold cut off piece by hand
gure 4 )
3
4
ripping. Be careful as the cut off strip can
sag or twist, closing the cut and pinching the
pressure treated and freshly cut green
lumber can heavily load the saw which can
Fig. 1).
lead to stalling. Push the saw slower when this
Fig. 2)
occurs.
while the blade is moving.
contacts material to be cut. Starting the saw
forward into cut can lead to stalling or sudden
cut. This leads to blade binding and stalling.
movement during cut.
cut begins to go off line. This can cause
start a new cut on the line.
one tooth of the blade projects below the
the blade to dig into the material, climb out of
nails from lumber before cutting.
MOTOR
Be sure your power supply agrees with
your tool will operate on standard 60 Hz
that your tool will operate on standard 60 Hz
on the nameplate. Lower voltage will cause
All Black & Decker

INTENDED USE

This circular saw is designed for wood
cutting applications. Do not use water feed
attachments with this saw. Do not use
abrasive wheels or blades. Do not use under
wet conditions or in presence of flammable
liquids or gases.
SAVE THESE INSTRUCTIONS
6
( gure 7).