Advertisement
4. Slowly spread, and if necessary, rotate the 4-pole magnetic rings to converge red and blue lines at the
center of the screen.
5. Use the Menu Up/Down buttons to select G (Green), and use the Menu Right button to set Green to
maximum.
6. Slowly spread, and if necessary, rotate the 6-pole magnetic rings to converge red/blue on green lines
at the center of the screen.
7. Repeat steps three and five for optimum performance.
8. Proceed to the Dynamic Edge Convergence Adjustment.
Dynamic Edge Convergence Adjustment
Note: To secure the correct position of the deflection yoke, three rubber wedges are used. They are
ultimately to be placed as shown in
1. Apply a crosshatch pattern to the antenna/cable input terminal.
2. Use the Menu Up/Down buttons to select G (Green), and use the Menu Left button to set Green to
minimum.
3. Tilt the yoke up and down to converge the red and blue vertical lines at the 6:00 and 12:00 positions
and the red and blue horizontal lines at the 3:00 and 9:00 positions
correct position has been found, place a rubber wedge between the yoke and the CRT. If the yoke is
tilted up, place wedge one as shown in Figure 9a; if it is tilted down, place wedge one as shown in
Figure 10a.
4. Tilt the yoke to the left and right to find the point of best possible convergence of the red and blue lines
at the edges, top and bottom of the screen as
located, place wedges two and three as shown in Figure 9b or Figure 10b.
5. Remove wedge one and place it in the final position as shown in
6. Use the Menu Up/Down buttons to select Green, and use the Menu Right button to set Green to
maximum.
7. Proceed to the White Balance Setup.
Figures 9 & 10 - Wedge Placement
Figure 9c or Figure 10c.
shown in Figure 12.
(refer to Figure 11).
When the correct position is
Figure 9c or Figure 10c.
When the
Advertisement
