Table of Contents
Advertisement
GB
Step : 1 Connections (Essential)
■
Connect the display unit to Aerial, VGA, BNC and Scart
connector as required.
Security fixing point
1. Connect the in-line power connector to the connector attached to
the display unit as shown above.
2. Connect the power cord of the display unit to a wall outlet.
✐
As this product does not have a mains On/Off switch, please
ensure your mains plug is easily accessible.
✐
The display unit is prepared for a mains voltage AC220~240V,
50Hz. To completely switch off the mains, or when the display unit
is not to be used for an extended period of time, it is advisable to
disconnect the power cord from the power outlet or disconnect the
mains coupler..
✐
Please use the correct mains lead supplied with the set for your
area
3.
Warning: To prevent injury, the unit must be securely attached to
the wall in accordance with the installation instructions.
WARNING! High voltages are used in the operation of
this set. Refer service to qualified service personnel.
1.■ HDMI (High Definition Multimedia Interface)
This TV set has an HDMI connector. When connected to the HDMI
source and HDMI is selected using the remote control,There is a short
time period before the picture appears at a much higher resolution.
This connection is located at the back of the TV set next to the aerial
socket.
4
INST
INST
Audio monitor
Wall
Out
AV2 audio
HDMI
IN
mount
Coaxial aerial IN
fixing
positions
Serial ports
IN/ Out
Services
AV3 IN/Out
BNC
AV2 IN/ Out
BNC
Inline connector
ALLA
TION
ALLA
TION
2. Y,Pb,Pr connection (AV2)
This LCD monitor has a choice of Y, Pb, Pr or RGB , H/V connections
You can connect your DVD player to the Y, Pb, Pr terminals instead
of using a scart lead. This can support high definition in analogue
component form. RGB, H/V can be used as a PC input via the BNC
terminal.
Service
3. PC connection
This LCD monitor has a PC connector.You
can connect a PC to the LCD monitor and use it as a monitor display
(see page 9).
To switch between TV, AV1, RGB, AV2 RGB H/V or Y, Pb, Pr, AV3,
HDMI or PC mode press the TV/ AV switch on your remote control
repeatedly or press and hold the TV/AV button for a few seconds and
selection menu will appear on screen use the e or d buttons to select
the correct mode.
4. RS232C IN/OUT: Is a input for external commands to control the
monitor (see page 9)
Step : 2 Remote control battery installation
Install two "AA" 1.5 volt batteries so that the "+" and "-" marks on the
batteries match the "+" and "-" marks inside the unit into the remote
control handset.
GB
Serial
Port-IN
Serial
Port-OUT
Advertisement
Table of Contents
