Table of Contents
Advertisement
BEFORE OPERATION
When using this Remote Control Unit as Wired Remote
Control, Connect Remote Control Unit to R/C JACK with
Remote Control Cable (supplied). Batteries installation is
required when using as Wired Remote Control Unit.
Remote Control
Cable (supplied)
Remove the battery
1
compartment lid.
Pull up the lid
and remove it.
To insure safe operation, please observe the following precautions:
G Use (2) AA, UM3 or R06 type alkaline batteries.
G Replace two batteries at the same time.
G Do not use a new battery with a used battery.
G Avoid contact with water or liquid.
G Do not expose the remote control to moisture, or heat.
G Do not drop the remote control.
G If a battery has leaked on the remote control, carefully wipe case clean and install new batteries.
G Risk of explosion if battery is replaced by an incorrect type.
G Dispose of used batteries according to the instructions.
14
WIRED REMOTE CONTROL OPERATION
ON-OFF
PICTURE
MUTE
➡
INPUT
BACK
MENU
OK
LOCAT
2-Win
SIZE
STATUS
WIDE
ON-OFF
F
PIP
REMOTE CONTROL BATTERIES INSTALLATION
Slide the batteries
2
into compartment.
NOTE: Wireless Remote Control does not work
when
connected on Plasma Monitor or Remote
Control.
3
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
Remote
Control
Cable
Replace the compartment lid.
is
Advertisement
Table of Contents
