GE AW18 Use And Care & Installation Manual page 5

For normal cooling
1. Set the Selector Switch at HI
COOL.
2. Set the Thermostat Control at
the desired number (usually 4-6 is
temperature is not satisfactory
after a reasonable time, set the
Thermostat Control at a higher
number for a cooler room or at a
lower number for a warmer room.
3. Set the Ventilation Control at
CLOSE except for brief periods
when you want to exhaust room air
to the outside.
For maximum cooling
1. Set the Selector Switch at
HI COOL.
2. Turn the Thermostat Control
to 8.
3. Set the Ventilation Control at
CLOSE.
For quieter operation
1. Set the Selector Switch at the
LO COOL position.
2. Turn the Thermostat Control to
the desired number.
3. Set the Ventilation Control at
CLOSE.
For nighttime operation
During the cooler evening hours,
we recommend that you set the
Selector Switch at LO COOL
for quieter operation and the
Thermostat Control at mid-range
(4 or 5). Set the Ventilation Control
at CLOSE.
For extreme temperatures
For greatest economy and best
performance, we suggest you set
the Selector Switch at HI COOL in
extremely hot weather.
To adjust air direction
Up and down
The up-and-down air direction
louvers are controlled by tabs thal
let you position the louvers to
discharge the air up, down or
straight out.
Side to Side
I
I 1 1 1 1 1 1 ]
OFF
For fixed side-to-side air
direction, set the Circulaire Switc
to ON until the desired air directio
is obtained, then move it to OFF.
For continuous side-to-side air
circulation, set the Circulaire
Switch to ON and leave it there.
ON