Refrigerator Door And Freezer Drawer Removal - LG LSFS213 series Owner's Manual

HANDLE REMOVAL
HANDLE REINSTALLATION
Mounting
Fasteners
1 Place the handle on the door by aligning handle
footprints to fit mounting fasteners and tighten the
set screws with a 2.5 mm (3/32") Allen wrench.
NOTE: If the handle mounting fasteners need to be
tightened or removed use a 1/4" Allen wrench
wWARNING
When the customer takes apart the handle or
assemble it from a refrigerator, please be cautious of
following things.
• Hold the handle with your own hand to make sure
not to drop the handle to the floor or instep while
taking apart the handle from a refrigerator.

REFRIGERATOR DOOR AND FREEZER DRAWER REMOVAL

REFRIGERATOR DOOR REMOVAL
wWARNING
Electric Shock Hazard
• Disconnect electrical supply to the refrigerator before
installing. Failure to do so could result in death or serious
injury.
• Do not put hands or feet or metal sticks into the air vents,
base grille, or bottom of the refrigerator. You may be
injured or receive an electrical shock.
• Be careful when you work with the hinge, base grille, and
stopper. You may be injured.
Before you begin, remove food and bins from the doors.
If your entrance door is too narrow for the refrigerator to
pass through, remove the refrigerator door and move the
10
refrigerator sideways through the doorway.
(CONT.)
2 Place the handle on the door by aligning handle
footprints to fit mounting fasteners and tighten the set
screws on the bottom of the handle with a 3.1 mm
(1/8") Allen wrench.
NOTE: If the handle mounting fasteners need to be
tightened or removed use a 1/4" Allen wrench.
• Do not swing the handle towards people or animals
after taking apart the handle.
• Insert the bracket hole of the handle into the stopper
bolt of the door exactly, and then assemble the set
screws to fix the handle.
• Check if there's any gap between the door and
handle after fixing the handle.
1 To remove the left refrigerator door:
Pull the water tube out of the fitting while pressing the
release ring on the fitting.
NOTE : When you pull out the tube, first you have to
push the collet by opposite direction of arrow in the
upper picture and pull the tube out by direction of
arrow.
Collet