Table of Contents
Advertisement
on the back of the fixture.
You can set the same starting address for all fixtures or a group of fixtures, or set
different address for each individual fixture. Be advised that setting all you fixtures to
the same DMX address will subsequently control all fixtures in the same fashion, in
other words, changing the settings of one channel will affect all the fixtures
simultaneously.
If you set each fixture to a different DMX address, each unit will start to "listen" to the
channel number you have set, based on the quantity of control channels (DMX
channels) of each fixture. That means changing the settings of one channel will only
affect the selected fixture.
In the case of the Impression 120RZ ™, which is up to a 15 channel fixture, you
should set the starting DMX address of the first unit to 1, the second unit to 16 (15 +
1), the third unit to 31 (15 + 16), and so on.
Note: During start-up the Impression 120RZ ™ will automatically detect whether a
DMX data signal is being received or not. If a DMX data signal is being received, the
display will show "A.XXX" (XXX representing the actual DMX address). If the fixture
is not receiving a DMX signal the display will flash repeatedly "A.XXX" (XXX
representing the actual DMX address).
If your fixture is connected to a DMX controller and the display is flashing (not
receiving a DMX signal), please check the following:
- The 3-pin plug (cable with DMX signal from controller) may not be
connected or is not inserted completely into the DMX input jack.
- The DMX controller is switched off or defective.
- The DMX cable or connector is defective.
- A DMX terminator has been inserted into the last fixture in your DMX
chain.
Elation Professional • Los Angeles, CA.
Error! Reference source not found. / Error! Reference source not found.)
18
Advertisement
Table of Contents
