Elation impression rgb 120rz User Manual page 10

electronics.
6. DMX Output Jack – This 3-Pin XLR jack is used to send an outgoing DMX
signal. For best results this jack should be terminated if it is the last fixture in
a DMX daisy-chain (see termination on page 19).
7. DMX Input Jack – This 3-Pin XLR jack is used to receive an incoming DMX
signal.
8. Electronics Fuse Holder – This housing holds a 250v/4A GMA fuse (120v
operation). Never defeat this fuse, this fuse is designed to protect the
electronics in the event of severer power fluctuations. In the event of fuse
failure, always be sure to replace this fuse with an exact match unless
otherwise instructed by an authorized Elation technician.
9. Powercon Connector – This power jack is designed to be used only with
the Neutrik Powercon adapter included with your fixture. This jack provides
main power to your fixture.
10. Safety Cable Mounting Point Connection – The fixture includes two safety
cable slots intergraded into the base. Be sure to use these slots as a
secondary rigging point to secure the fixture in the event a clamp fails.
Elation Professional • Los Angeles, CA.
Error! Reference source not found. / Error! Reference source not found.)
10