Princess 535596 Instructions For Use Manual page 6

DETAILS
Practical rechargeable (cordless) clipper has a powerful motor, steel cutting blade, and also serves as an
adaptor for charging the batteries. Splash-resistant - can be used in the shower, but not under water.
Complete with adjustable comb attachment with 6 positions (15, 17, 20, 23, 26 and 29mm), comb, scissors,
charge adapter, cleaning brush and a bottle of oil. The comb attachment is used to set different cutting
lengths. This makes cutting and trimming so easy that even as a home hairdresser, you can achieve
professional results.
CHARGING THE BATTERIES
Prior to using for the first time, the hair trimmer must be fully charged.
1. Slide the on/off switch downwards to make sure it is switched off.
2. Insert the plug of the mains adaptor into the power jack of the hair trimmer.
3. Plug the mains adaptor into a power socket outlet.
4. It takes approximately 16 hours to charge the batteries for the first time. Every further charging phase
takes approximately 12 hours. The remaining battery time for completely charged batteries is approximate
60 minutes.
5. When charging is complete, remove the adapter from the wall socket.
Note: To increase the life of the rechargeable batteries, the batteries should be fully charged prior to being
used for the first time, and be used until the batteries are completely empty.
DIRECTIONS FOR USE
Switch on the clippers with the slide switch.
Only use the clipper cordless, not connected.
Sliding the comb attachment will change the cutting length: sliding it forward will produce a longer
length, and backward will result in a shorter length.
he comb attachment is simply clicked onto the clipper.
To remove the comb attachment after unlocking the button, pull it up.
When you want a different length, you can simply unlock the comb attachment by pressing the clip on the
comb attachment and sliding the comb attachment.
Before you start cutting:
- First check the clippers. Make sure there are no hairs or dirt on the clippers. Switch on the clippers and
check whether they are working properly.
- Drape a towel around the neck of the person whose hair you are about to cut.
- Seat the person is such a way that his/her head is at eye level for you, enabling you to see better and
work more comfortably. If necessary, use books or cushions to raise the person to eye level.
- First comb the hair, removing any knots or tangles. Now hold the clippers as comfortably as possible.
- Relax and work with precision, making short "runs". Do not shave off the side or back of the hair
straightaway; work gradually over the entire head.
- It is better to remove a small patch at a time. You can always remove more later.
- Before you start and while you are working, comb the hair regularly into the desired hairstyle.
To start cutting
When working with the clippers for the first time, cut only a small part of the hair until you become used
to the amount of hair that is cut off with a particular setting.
After the hair has been combed into the natural direction of growth, proceed as follows to achieve a
flowing, tapering hairstyle:
Step 1. The neck section
Use comb attachment Hold the clippers with the cutting side up and start cutting in the
middle, at the bottom of the neck. Hold the clippers lightly against the head with the teeth
of the comb attachment facing up. Gradually move the clippers upwards, work up and to
the outside through the hair, removing only a small part at a time. While cutting, gradually
move the head of the clippers towards you. Then cut the back section from the beginning
of the neck to above the ears.
Step 2. Back of the head
Use comb attachment to cut the back of the head.
6