Restoring A Pre-Programmed Setup - GTCO CalComp DrawingBoard III User Manual

Setting up for MicroStation (DOS only)
Using CalComp 9100 format:
Setting up forTimberline
Using CalComp 9100 format:
Using Summagraphics MM 1201 binary format:
Setting up for VersaCAD
Using CalComp 9100 format:

Restoring a pre-programmed setup

When you save a custom setup to one of the save areas, the pre-programmed setup will be overwritten. To
restore the original setup, set the Configuration keys as shown below, using the procedure on the following
page. The circles represent the power light on the tablet. Bank C does not vary for these applications so it is not
included in the description.
= Power Light ON = Power Light OFF
Restoring Save Default — GTCO DP5 High Resolution
Restoring Save 2 — Summagraphics MM 1201 binary
- 18 -