Selecting A Custom Setup - GTCO CalComp DrawingBoard III User Manual

To select one of the other setups:
1 Turn on configuration mode by clicking on the Config/Exit key. The configuration light will turn on
and remain on while the tablet is in configuration mode.
2 Click on the desired Restore key.
3 Click on the Config/Exit key again to exit configuration mode. The new setup is activated.
The following table lists the tablet options used by the pre-programmed setups.
Default
Mode
Run
Baud Rate
9600
Data Bits
8
Parity
None
Data Rate
125 pps
Resolution
1000 lpi
Output Format
Format 23
Emulation
GTCO DP5
High Resolution
Binary

Selecting a custom setup

You can setup specific tablet options by turning different combinations of Configuration keys on or off. The
available tablet options
To set up the tablet:
1 Turn on configuration mode by clicking on the Config/Exit key. The configuration light will turn on
and remain on while the tablet is in configuration mode.
2 Click on the Bank key where you need to work (A, B, or C). You can determine which bank you
are in by placing the pointing tool over one of the Bank keys. The power light is on if the bank is
active.
3 Determine whether the Configuration keys are on or off by placing the pointing tool over each
key. If the key is on, the power light is on; if the key is off, the power light is off. Click on the key
to toggle the setting, if necessary.
4 Repeat steps 2 and 3 for the remaining banks as required.
5 After you have completed your setup, you can save it by clicking on one of the Save keys.
Caution: Clicking on a Save key will overwrite the pre-programmed setup. This step may be omitted if the setup
is temporary for the current session, but the setup will be lost when the tablet is powered off. Only save your
setup when you will need it for repeated work sessions.
If you overwrite a pre-programmed setup, see
restoring the original settings.
6 Exit configuration mode by clicking on the Config/Exit key. The configuration light will turn off.
Save 2
Track
9600
8
Odd
150 pps
500 lpi
Format 30
Summagraphics
MM 1201 Binary
are listed below.
Save 3
Point
9600
7
Even
125 pps
200 lpi
Format 0
CalComp 2000
ASCII
Restoring a pre-programmed
- 11 -
in this section for information on