Input Device Is Connected With The Zero Signal; Connecting Components To The Usb Port; About Usb Devices; Connecting The Usb Device - Pioneer BDP-88FD Operating Instructions Manual

Input device is
02
connected with the
ZERO SIGNAL terminal.
The Zero Signal is the reference (GND) for video and audio
signals. If you connect the ZERO SIGNAL terminal of the
equipment to the audio input terminal of another device
connected to this equipment, with a pin cord, the device
becomes compatible to the audio standard of this
equipment, and the signal integrity improves.
On the other hand, if you connect the video input terminal
of the device, it will become compatible to the video
standard of this equipment and the signal integrity will
improve.
AV receiver or TV etc.
Connecting components
to the USB port

About USB devices

The USB devices that can be connected to the player are
as shown below.
• USB 2.0-compatible USB flash drive (capacity of 1 GB
or greater, 2 GB or greater recommended) or HDD
(capacity 2 TB or less)
• File system: FAT16, FAT32 or NTFS
Note
• Devices formatted with a file system other than the
above cannot be used.
• USB devices may not be recognized if they contain
multiple partitions.
• Some USB devices may not operate with this player.
• Operation of USB devices is not guaranteed.
22
En
ZERO SIGNAL RS-232C
HDMI OUT DIGITAL AUDIO OUT LAN
(10/100)
SUB MAIN
OPTICAL COAXIAL
To audio or video
input terminals

Connecting the USB device

Caution
• Be sure to turn the player's power off before
connecting or disconnecting USB devices.
• When using an external hard disk as the external
storage device, be sure to turn on the hard disk's
power before turning on the player's power.
• If the USB device is write-protected, be sure to disable
the write-protection.
• When connecting the USB cable, hold onto the plug,
set the plug in the proper direction for the port and
insert it horizontally.
• Placing excessive loads on the plug may result in
poor contact, making it impossible to write data on
the USB device.
• When a USB device is connected and the player's
power is turned on, do not unplug the power cord.
USB
USB flash drive
ZERO SIGNAL
OUT DIGITAL AUDIO OUT
MAIN
OPTICAL
USB flash drive
Note
• Devices may not work if connected to the USB port via
a memory card reader or USB hub.
• Use a USB cable with a length of 2 meters or less.
BDP-88FD's front panel
USB cable
(commercially
available)
BDP-88FD's rear panel
RS-232C
LAN USB
(10/100)
COAXIAL
USB cable
(commercially
available)
Hard disk, etc.
Hard disk, etc.