Table of Contents
Advertisement
Camera Status Lights
Your TRUTH
Camera is equipped with 2 LED status indication lights on
®
the front of the camera (located right above door opening on each side
of PIR Motion Sensor).
Green Light
RED LIGHT
Lights up when the camera detects motion. After you close camera door
and are standing in front of the camera, visibility of this light is indication that
your camera is ON and working.
(TIP: Walk in front of the camera and look for the red light to illuminate when you are detected.
You can do this to verify your camera is pointing in the correct direction
30 second delay from the time the camera is turned on till it is ready to take pictures.)
GREEN LIGHT
Lights up when the camera takes photo or is recording a video. The green light
stays on while the photo/video is being stored on the SD Memory Card.
(NOTE: Do not remove SD Memory Card when the green light is blinking – this could cause you
to lose all data on memory card!)
(NOTE: The LCD menu will not wake up from ON/RUN mode [Power Saving State] while the
Green Status Light is on. Wait until after Green Light turns off to WAKE up LCD screen by pushing
the WAKE button.)
Red Light
ON/OFF PROGRAM
RUN/ WAKE
SET
.
Remember there is a
7
CAMeRA MeNU OpTIONS
Initial PRIMOS
Menu Screen
-
®
camera status, number of pictures '0074',
time, battery life and date.
Example: Camera Menu is on and 74 picture/videos
are on SD Memory Card
If SD Memory Card is NOT installed,
screen will display "NO SD" instead of
4-digit '0000' picture count.
PLEASE INSERT SD CARD
- Select camera MP (Megapixel) setting or
Camera or Video (CAM_VID)
video length in S (Seconds). For help selecting camera or video settings see
(pg. 2)
Example: 5.0 Megapixel photos will be taken
displays
If SD Memory Card is FULL, screen
will display "SD FULL" instead of 4-
digit '0000' picture count.
PLEASE REPLACE SD CARD
Example: 30 second High Res videos will be recorded
8
Hide quick links:
Advertisement
Table of Contents
