Quick Start Initial Camera Setup; Easy 6 Step Setup; Camera Settings Backup Battery - Primos Truth Cam46 63020 Instruction Manual

QUICK START INITIAL CAMeRA SeTUp

Easy 6 Step Setup

1. Install Batteries - Uses four (4) "D"
size Alkaline or Rechargeable batteries.
(Note: Camera identifies fully charged rechargeable
batteries, such as NiMH, as less than 99% on battery
indication level. Rechargeable batteries run on
different voltage and cause this variation. Most fully
charged rechargeable batteries will show 50-60%.)
2. Install up to 8GB SD Memory Card (not included) into the card slot
on the bottom of the camera. If SD Card is not installed, camera will display
"NO SD" on Initial Primos Menu Screen.
seal [plug]. Open door of the camera and gently rotate seal from slot. After SD Memory Card is
installed, replace rubber seal in original position to prevent moisture and elements from entering
camera and possibly causing malfunction.)
3. Secure Camera to Tree or Pole using included Mounting Strap
(must thread strap through Mounting Strap Slots on back of camera).
Turn On Camera and Review Default Settings on by holding down
4.
ON/OFF button for 2 seconds. The LCD screen will turn on and show the
Camera Menu. Push UP or DOWN arrows to navigate through all Menu
options. For convenience and simplicity, your camera has the following
DEFAULT SETTINGS:
DEFAULT SETTINGS:
(Note: SD Card Slot is protected by rubber
Camera Menu Default Other Settings
Camera - 5MP, 2.0MP
Video - High Res - 15s, 30s
Camera or Video
3MP
Video - Low Res - 15s, 30s, 60s
Number LED's 46LED 25LED
Delay 1 Minute 5s, 10s, 30s, 30M, 60M
Burst 1 Picture 3 Picture, 5 Picture
Sensing Level Normal High, Low
Time N/A User needs to set
Date N/A User needs to set
MP - Megapixel s - Seconds M - Minutes
5
5. Setup-Time and Date - Navigate through menu options to find Time and
Date screens. While on respective screen, press Program/Set button and
then buttons to adjust selected field.
6. Your camera is ready to use! Press RUN/
menu and turn camera into active RUN mode. After 30 seconds the TRUTH
Camera will be armed and ready to take pictures whenever the Motion Sensor
detects motion or movement.
(NOTE: TEST camera before placing in field/woods. Run
camera in live "On/Run" mode and make sure Photos/Videos are being saved on SD Card. Can
view number of Photos/Videos being saved from external window.)

Camera Settings Backup Battery

*** This TRUTH Camera is equipped with an internal rechargeable backup
®
battery that is dedicated to saving the date, time and menu settings when the
main D-cell batteries are removed. This internal backup battery can preserve
your settings for up to 6 months when fully charged.
a long period of time without camera use, internal battery may initially take up to 30 hours to fully
charge - charges only when "D" batteries are installed when camera is turned ON.)
button to quickly exit
WAKE
(NOTE: With first use or after
6
®