Initial Operation; Setting Up The Device; Connecting Power Supply / Charging Battery; Initial Installation - Philips PicoPix PPX3414 User Manual

3 Initial Operation

Setting up the Device

You can position the device so that it lies flat on a table
in front of the projection surface; it is not necessary to
tilt it towards the projection surface. The device com-
pensates for the distortion from the slanted projection
(pincushion distortion).
A tripod accessory is available if you want to elevate the
device (Pico Tripod / 253521272).
Connecting power supply /
Charging battery
CAUTION!
Electrical Voltage at the Site of Installa-
tion!
Check whether the electrical voltage of the
power supply matches the electrical voltage
available at the setup location.
1 Insert the small plug of the power supply into the
socket on the rear side of your device.
2 Plug the power supply into the power outlet.
3 During the charging process, the indicator light on
the side of the device will be red. When the battery
is fully charged, it will turn green.
4 Charge the built-in battery before using for the first
time for at least 3 hours. This will prolong the life of
the battery.
Initial Operation

Initial Installation

1 Switch the device on using the on/off switch on the
side.
2 Turn the device towards a suitable projection sur-
face or wall. Note that the distance to the projection
surface must be a minimum of 1.64 feet and a maxi-
mum of 16.4 feet. Make sure the projector is in a
secure position.
3 Use the focus wheel on the top to adjust the image
sharpness.
4 Select the desired menu language using
5 Confirm with à.
Note
The main menu appears instead of
the language selection
The device has already been installed. In
order to change the menu language, pro-
ceed as follows:
1 Use the navigation keys to select Set-
tings.
2 Confirm with à.
3 Select with
4 Confirm with à.
5 Select the desired language with
6 Confirm with à.
7 Exit with
.
Language.
.
.
9