Table of Contents
Advertisement
F
B
H
A
A Piezo Ignitor
B Mounting Screws
C Lead Wires to Valve G Remote Receiver
(red & white)
D Push-on Retainers
Fig. 6 Wireless remote receiver installation.
Switch
Fig. 7 Route thermostat wire under logset.
B
T111
Bottom view
10/27/03 djt
Existing Wiring
Fig. 8 Thermopile Switch (OFF/ON).
10
C
E
B
E Battery Terminal
F Receiver Bracket
T110
remote install
10/27/03 djt
H Switch (OFF/ON)
Bottom View
A
T112
Thermopile switch
10/27/03 djt
Installation of Millivolt Wall Switch
To install your millivolt wall switch, an approved wall box
should be installed in a location suitable to you. The
G
thermostat wire should be routed from the wall box to
the log set and should be routed underneath the log set
as shown in Figure 7 and pulled up to the valve's wiring
terminal as shown in Figure 8.
D
The two wires, letter "A", should not be removed or
changed. Remove switch wires, Letter B. The two fe-
male ends of your wire can be connected to the two outer
connections just below the screw terminals as shown in
Figures 9 & 10.
Now the wall switch can be wired as shown in Figure 11.
The red and white wires can be connected to either poles
as they carry only millivolt current. No ground is used at
the wall switch. See the lighting instructions for the mil-
livolt wall switch in the operating manual.
Recommended Maximum Lead Length (Double Wire)
When Using Wall Switch or Thermostat
T110
NOTE: Must be stranded wire.
C
B
C
T111
Fig. 9 Connect two (2) female ends to outer connections.
Fig. 10
T112
Wire Size
Max. Length
14 ga.
50 ft.
16 ga.
32 ft.
18 ga.
20 ft.
20 ga.
15 ft.
22 ga.
10 ft.
A
Thermopile (Do Not Remove)
B
Switch
C
Wires from Receiver (red &
white) or Wires from Millivolt
Wall
B
A
T113
Fig. 11
Thermopile switch
10/27/03 djt
T114
20008055
Advertisement
Table of Contents
