Docking Station; Opening And Closing; Connecting Apple® Devices; Usb Hub - Victor MR500 User Manual

increase the volume. Turning the knob counterclockwise (left) will
decrease the volume.

Docking Station

Opening and closing

To open the docking station⑥, push the TOUCH icon. The docking
station will click inwards, and then a spring will pop the dock out. Pull the
dock out completely until the internal magnetic locking pin engages. This
feature will hold the docking station in place while you use your Apple®
device. To close the docking station, press firmly on the TOUCH icon to
glide and click the dock back into place.
Connecting Apple® devices
To connect your Apple® products, place the device on the Apple®
connecting pin that sticks up from the docking station⑥. This is the same
pin found in cables that are supplied with genuine Apple® products. Once
your product is placed on the connecting pin, the Monitor Riser will
automatically begin reading. You can now use the connected Apple®
device to control the music being played. If you would like to charge your
device and connect to the computer, you must have the Monitor Riser
powered by both the USB Type B cable⑬ and the DC 5V power cable⑮.
NOTE: Due to the iPad's™ electrical configuration, the iPad™ can only be
charged when powered by the DC 5V power cable⑮ exclusively. When
connected by USB Type B cable⑬, charging is disabled.

USB hub

Using the USB hub

The high speed USB 2.0 hub can be used when the Monitor Riser is
powered by the USB type-B input⑬ or the DC 5V input adapter⑫.
7