Table of Contents
Advertisement
2.
WHEN CONNECTING TO THE AIR SUPPLY:
A. Wrap approximately 4" of Teflon tape around the male threads of a Quick
Connector (not provided). Then, wrench tighten the Quick Connector into the Air
Inlet Bushing (part #1) of the Air Nibbler. (See Figures A, B, and Assy. Dia-
gram.)
B. If an automatic oiler is not used, add two drops of oil into the Quick Connector
of the tool.
C. Turn on the compressor and set the regulator to the pressure recommended
for this tool (90 PSI).
3.
ALWAYS DISCONNECT TOOL FROM ITS COMPRESSED AIR SUPPLY
SOURCE BEFORE PERFORMING ANY SERVICES OR MAINTENANCE such
as cleaning the tool, moving to a different work location, handing the tool to
another person, etcetera.
4.
MAINTAIN A SAFE WORK ENVIRONMENT. Keep work area well lit. Make
sure there is adequate surrounding work space. Use this product in a well venti-
lated area. Do not operate this product in the presence of flammable liquids,
gasses, or dust.
5.
DO NOT FORCE THE EQUIPMENT. This product will do the work better and
safer at the speed and capacity for which it was designed.
6.
AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin
work before depressing the Throttle Lever (part #2). (See Figure B, and Assy.
Diagram.)
7.
WARNING: This product contains or produces a chemical known to the State of
California to cause cancer and birth defects (or other reproductive harm). (Cali-
fornia Health & Safety Code 25249.5 et seq.)
8.
Some dust created by power sanding, sawing, grinding, drilling, and other construc-
tion activities, contain chemicals known [to the State of California] to cause cancer,
birth defects or other reproductive harm.
SKU 46061
PAGE 4
FIGURE A
REV 04/06
Advertisement
Table of Contents
