Table of Contents
Advertisement
SYMBOLS & LABELS
THE FOLLOWING SYMBOLS & DEFINITIONS ARE FOUND THROUGHOUT THIS MANUAL AND
ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES.
WARNING
CAUTION
IMPORTANT
• Always turn the compressor source OFF, and ensure air lines are decompressed
and disconnect the chain saw from the air hose (even when the compressor is OFF
when performing maintenance on the saw including chain tensioning.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE SAW
• Never use equipment that is not functioning properly. Have the saw repaired by a
qualified service personnel.
• Diamond chains require a minimum water pressure of 20 PSI. Insufficient water
supply may result in excessive wear to the chain which can lead to loss of strength
and chain breakage.
• Never start a diamond chain saw unless the bar, chain, and side cover are properly
installed.
General Safety Precautions
• Always wear protective clothing, including hard hat, eye protection, hearing
protection, and gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on the saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts, etc.) and
4
no unnecessary people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust
gases is dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.
TITLE
A potentially hazardous situation exists which, if not avoided,
could result in death or serious injury.
This symbol applies to all information listed on this page
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
A potential situation exists which, if not avoided, may result in
product or property damage.
Read the operator's manual carefully and understand the
contents before you use this equipment.
Always use:
• Protective helmet
• Ear protection
• Protective glasses or full face protection
Wear hand protection
Air Powered Chain Saw
633GC / 633F4 OPERATOR'S MANUAL
Safety
© 2011 ICS, Blount Inc.
F/N 70944 May 2011
5
Advertisement
Table of Contents
