Table of Contents
Advertisement
Store your fireplace insert in a dry, safe and
dustless place when placing the mantel or building
the wall construction.
5.
If there's no 15A/125V outlet near the desired location, install a
new one near or behind mantel.
WARNING
Do not attempt to wire you own new outlets or
circuits. To reduce the risk of fire, electric shock or
injury to persons, always use a licensed electrician.
6. Make sure the fireplace insert is switched off (refer to
operation instruction section).
7. Plug the fireplace into a 15A/125V outlet. Wiring the cord along
the corner of wall.
8. Push the fireplace insert into place so that the panel and the
finished mantel surround or wall surface are in the same plane.
Instruction for use
The fireplace can be operated either with the switches located on the
top right hand side of the fireplace or with the supplied remote control.
Manual Operation
•
This is done by operating
the switches located at the
bottom right hand side of
the fire. The standby switch
must first be switched on.
The fireplace will beep to
indicate that it is powered
Advertisement
Table of Contents
