Summary of Contents for Crown QR-23
- Page 1 Embedded Electric Fireplace Instruction Manual MODEL: QR-23 AC 110-120V~ 60Hz 1500W PLEASE READ ALL INSTRUCTIONS CAREFULLY AND RETAIN THIS MANUAL FOR FUTURE REFERENCE...
-
Page 2: Quick Reference Guide
QUICK REFERENCE GUIDE Remove the fireplace from the box. Remove all the packaging and place it inside the box and either store or dispose of safely. III. Prior to installation, please ensure: The rated voltage of your fireplace fits the output voltage of your outlet;... -
Page 3: Important Instructions
IMPORTANT INSTRUCTIONS WARNING should read and always follow the instructions mentioned below to reduce the risk of fire, electric shock, and injury. 1. Read all instructions before using this fireplace. 2. This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot surfaces, such as surfaces near the fireplace outlet or light bulbs. - Page 4 12. Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 13. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the fireplace.
- Page 5 26. When transporting or storing the fireplace and cord, keep in a dry place, free from excessive vibration to avoid damage to the fireplace. 27. WARNING: In order to avoid overheating, do not cover the fireplace. 28. This fireplace is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction...
- Page 6 Installation This section provides step-by-step instructions for installation of your fireplace. WARNING The outlet must be 15A/125V. CAUTION Do not remove the four rubber feet at the bottom of the fireplace insert or install the fireplace insert directly on soft surfaces, which may restrict air circulation.
- Page 7 Store your fireplace insert in a dry, safe and dustless place when placing the mantel or building the wall construction. If there's no 15A/125V outlet near the desired location, install a new one near or behind mantel. WARNING Do not attempt to wire you own new outlets or circuits.
- Page 8 • Press the on/off button once to turn on the fireplace with fire effect. A red indicator light will illuminate to indicate that the fireplace is on. • Press the low button once, to lower the heat; press twice to switch off the heat completely.
-
Page 9: Troubleshooting
• Press the Lamp button is on or off the brightness of the fire effect. Safety Cut-Off • This fireplace is equipped with safety cut-off feature which will operate if the fireplace overheats (e.g. Due to blocked air vents). For safety reasons, the fireplace will NOT automatically restart. - Page 10 the flame or when the clarity and detail of the log exterior disappears. There are two bulbs under the log set. WARNING Allow at least 5 minutes for light bulbs to cool off before touching bulbs to avoid burning of skin. I.
-
Page 11: Cleaning And Maintenance
Cleaning and Maintenance • Warning: Always disconnect from the power supply before cleaning the fireplace. • For general cleaning use a soft, clean duster. Never use harsh abrasives or cleaners. The glass screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners.