Viking 3 Series Use And Care Manual page 15

Operating the Dishwasher
Start/Pause/Cancel Button
Use this button to start the selected program. when the button is pressed once, the light on the button will turn on.
RESET
Stop the program with the Start/Pause/Cancel button.
3 sec.
Remaining Time Indicator/Delay Time Indicator
You can follow the remaining program duration from the time indicator display.
Delay Start Button
This option enables you to start the selected program with a delay of .5 to 9.5 hours.
• Delay time is adjusted by pressing the Time Delay button (press several times).
• After adjusting the delay time, press the Start/Pause/Cancel button.
• Close the door. At the end of the delay set, the program starts automatically.
During a wash program, the Delay Start option does not function.
Cancellation of a Function
To cancel a program while the dishwasher is running:
• Open the door gently.
• Press and hold Start/Pause/Cancel button for 3 seconds. The indicator light will start fl ashing.
• Close the door.
• The dishwasher will drain the water inside the machine for 2 minutes. At the end of the cycle, a beep will sound. You can choose
and start a new program.
Depending on the stage of the program you have cancelled, there may be detergent
residue or rinse agent inside the machine and on the dishes. Make sure the items
in the dishwasher are not used before washing properly. Ingestion or inhalation of
detergent or rinse agent may cause serious injury. Avoid contact with skin and eyes
and keep children and people in poor health away from these materials.
Program Change
To change the program selection while the dishwasher is running:
• Open the door gently.
• Press Start/Pause/Cancel and select a new program.
• Press Start/Pause/Cancel again, to start.
Depending on the length of the terminated program, detergent and rinse agent may
still be in the dispensers. Ingestion or inhalation of detergent or rinse agent may
cause serious injury. Avoid contact with skin and eyes, and keep children and people
in poor health away from these materials.
Changing Volume of Sound Indicator
Press and hold Function button for 5 seconds until S:03 appears on the display. Every time you press the Function button, the
warning sound level will change as - - Off , S:01 Low, S:02 Medium, and S:03 High. After selecting the sound volume, wait for 10
seconds to save it. Factory setting of your machine is S:03.
NOTICE
WARNING
WARNING
15