Signal Light Status; Power Light; Feed Light; Specifications - Brecknell CP103 User Instructions

1.6 Signal Light Status

1.6.1 Power Light

Power Light
Steady red light
Red light blinks one time slowly every one second
Steady green light
Blinks between red and green light
Blinks 3 times between red and green light
No light

1.6.2 Feed Light

Feed light
Steady red light
Red light blinks quickly (2 times/sec)
Red light blinks 3 times and then stops
Steady green light
Always alternating blink between red and green light

1.7 Specifications

Item
Dimension (W×D×H) 104×75×48mm
Weight 145g (without battery and paper roll)
Print Width 58mm
Print Speed 90mm/s (MAX)
Memory 10K byte buffer and 8M byte flash
Interface RS-232 baud rate 4800 - 115200bps
Resolution 8 dot/mm (203dpi)
Language Support Figure, English characters, bit-image, bar code, curve
Character Size ANK: 12*24(dot), 1.5*3.0 (W*L, mm);
Chinese Character: 24*24 (dot), 3.0*3.0 (W*L, mm)
Print Commands ESC/POS compatible command set
Other Features Paper auto-detection, power detection, thermal protection, with machine charging, automatic sleeping mode
Working Conditions Temperature: 0° - 50°, Humidity 20% - 85%
Storage Conditions Temperature: -20° - 70°, Humidity 5% - 95%
4
Light Color Printer Status Specification
Red In the process of recharging battery
Red Battery power is low, recharge battery
Green Battery voltage is good
Red/Green Battery failure
Red/Green Printing is finished or printer is in power on mode
None No power is detected
Light Color Printer status specification
Red Feed paper or receiving data
Red No paper
Red Printer parameter setting is finished and ok
Green Printer status is ok but not connected bluetooth
Red/Green Printer dead, the buffer is full or temperature of
printhead is too high
Specification
CP103 Thermal Printer User Instructions