4.2.2 Set the Printer Data Bits
Change the data bits of the printer to match the host device.
1.
2.
Where n is the number associated with the desired data bits
Note: Dont change the paramter if possible. If set n=1, must set parity of COM.
4.2.3 Set the Printer Stop Bit
Change the stop bit of the printer to match the host device.
1.
2.
Where n is the number associated with the desired stop bit
CP103 Thermal Printer User Instructions
Go to the Testing tab.
Under the CMD Testing window (the top window) enter the following command
string:
+UART LEN:n
Go to the Testing tab.
Under the CMD Testing window (the top window) enter the following command
string:
+UART STOP:n
n
Data Bits
0
8 bit (default)
1
9 bit
n
Stop Bit
0
1 (default)
1
1.5
2
2
13